User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Operating System Specific Information
25Modular SAN Array 1000 User Guide
Microsoft Windows Environments
Windows-based configurations that use the MSA1000 may range from a simple
single-controller MSA1000 connected to a single node to a complex dual-node,
redundant-controller MSA1000 connected to a complex fabric supporting
multiple two-node clusters.
Supported Operating System Versions
■ Windows NT 4.0 Server
■ Windows 2000 Server
■ Windows Server 2003
Note: For a current listing of the supported operating system versions, see the
MSA1000 website at
www.hp.com/go/msa1000
.
Supported Software Components
■ Array Configuration Utility
■ Command Line Utility
■ Insight Manager 7
■ Microsoft Clustering Services (MSCS)
■ HP StorageWorks Secure Path for Windows Workgroup Edition
■ Storage Agents for Windows
■ OpenView Virtual Replicator
■ SmartStart and Support Software version 5.50 or later
230941-005_MSA1000_UG.book Page 25 Thursday, April 17, 2003 5:53 PM