User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
23Modular SAN Array 1000 User Guide
2
Operating System Specific
Information
The MSA1000 supports several operating systems and can be deployed into
heterogeneous environments with any combination of these operating systems.
Each operating system is introduced in a separate section of this chapter:
■ Microsoft Windows Environments, page 25
■ Linux Environments, page 26
■ Novell NetWare Environments, page 27
■ OpenVMS Environments, page 28
■ Tru64 UNIX Environments, page 31
For each environment, information about the supported operating system,
software components, and host bus adapters is detailed.
230941-005_MSA1000_UG.book Page 23 Thursday, April 17, 2003 5:53 PM