User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Introduction
10 Modular SAN Array 1000 User Guide
MSA1000 Controller Display
Each array controller in an MSA1000 contains an integrated Liquid Crystal
Display (LCD). This module is used for displaying informational and error
messages, showing the status of the module, and for providing user input when
required. Traditional Power-On Self-Test (POST) messages issued by PCI-based
array controllers have been combined with runtime event notification messages to
create a new set of controller display messages.
Figure 3: Controller display
\
For more information about the MSA1000 Controller display, see the “Controller
Display Messages” appendix.
Controller Display Description
1
Fault indicator (amber)
2
Display
3
Left push button
4
Up push button
5
Right push button
6
Down push button
7
Redundancy Link indicator (green)
1 2 3 4 5
67
230941-005_MSA1000_UG.book Page 10 Thursday, April 17, 2003 5:53 PM