User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Index
238 Modular SAN Array 1000 User Guide
cache batteries low recharging 208
cache data lost battery dead 206
cache disabled no configuration 208
cache error 210
cache hardware batteries missing 211
cache hardware enabled 207
cache hardware temporarily disabled 207
cache module size 206
chassis nvram contents corrupted 200
configured volumes 215
critical lockup detected 198
drive failure box, bay 212
drive hot added box, bay 211
drive hot removed box, bay 212
drive position change detected 212
drive position change invalid 212
dual cache module size mismatch 206
EMU flash done 221
EMU flash failed 221
EMU flash started 221
enable volume 198
enable volumes 198
fibre switch hardware failure 225
firmware flash done 221
firmware flash failed 221
firmware flash started 221
firmware version 198
initializing fibre subsystem 225
initializing PCI subsystem 224
initializing SCSI devices 199
initializing SCSI subsystem 199
new volume(s) detected 216
no cache module found 206
no volumes detected 216
obsolete cache data deleted 208
PCI bridge ASIC self-test failure 224
PCI subsystem hardware failure 224
read failure 200
recovery ROM autoflash done 219
recovery ROM autoflash failed 219
recovery ROM autoflash started 219
redundancy active active Controller 201
redundancy active standby Controller 201
redundancy failed cache DIMMS mismatch
206
redundancy failed cache size mismatch 203
redundancy failed firmware lockup 204
redundancy failed hardware failure 201
redundancy failed I/O request error 205
redundancy failed mismatch firmware 202
redundancy failed mismatch hardware 202
redundancy failed no second Controller 205
redundancy failed out of memory 204
redundancy failed PCI bus error 205
redundancy halted expand active 202
redundancy halted firmware cloned 203
replacement drive found box 211
restarting system 199
ROM cloning done 220
ROM cloning failed 220
ROM cloning started 220
scanning for SCSI devices 199
SCSI subsystem hardware failure 199
smart drive alert box 211
startup complete 198
storage box 221
storage box EMU not responding 224
storage box EMU version 224
storage box fan failed 222
storage box fan hot inserted 222
storage box fan hot removed 222
storage box overheated 223
storage box overheating 222
storage box power supply added 223
storage box power supply failed 223
storage box power supply ok 223
storage box power supply removed 223
storage box temperature ok 222
storage fan degraded 222
system halted for cache error 209
system name 199
too many volumes detected 216
uncorrected ECC memory error seen 225
valid cache data found at power-up 206
230941-005_MSA1000_UG.book Page 238 Thursday, April 17, 2003 5:53 PM