User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
231Modular SAN Array 1000 User Guide
H
SCSI ID Assignments
SCSI IDs are assigned automatically in the MSA1000 drive shelf and any
additional attached storage enclosures according to the drive bay used for each
drive.
The tables in this appendix show the assigned SCSI assignments and the SCSI
buses used for each of the drive bays in the MSA1000 and any additional attached
storage enclosures.
Note: Although the 4214 and the 4254 storage enclosures can be attached to the
MSA1000, optimum performance is obtained when using 4314 and 4354 storage
enclosures.
A separate table is present on each page of this appendix.
230941-005_MSA1000_UG.book Page 231 Thursday, April 17, 2003 5:53 PM