User guide

Controller Display Messages
219Modular SAN Array 1000 User Guide
300 RECOVERY ROM
AUTOFLASH
STARTED
Informational Indicates that the array
controller has detected that
the firmware’s backup
recovery ROM image is
invalid and is copying the
current active firmware
image into the backup
recovery ROM.
301 RECOVERY ROM
AUTOFLASH DONE
Informational Indicates that the array
controller has successfully
completed the process of
copying the current active
firmware image into the
backup recovery ROM.
302 RECOVERY ROM
AUTOFLASH FAILED
Error Indicates that the array
controller failed to copy the
current active firmware
image into the backup
recovery ROM. Recovery
ROM support is disabled.
Remove the failing
array
controller, wait 10 seconds,
and then reinsert the array
controller insuring that it is
fully seated in the chassis.
The ROM autoflash process
will be attempted again.
Should the issue persist
please contact HP support.
Table 20: LCD Message Descriptions
Message Type Description Action
230941-005_MSA1000_UG.book Page 219 Thursday, April 17, 2003 5:53 PM