User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Controller Display Messages
208 Modular SAN Array 1000 User Guide
68 OBSOLETE
CACHE DATA
DELETED
Informational Old data that no longer
belongs to any current
configured volumes was
found in the cache memory
at power up. This data has
been deleted. This typically
happens if cache modules
are moved between array
controllers.
69 CACHE
BATTERIES LOW,
RECHARGING
Informational The batteries on the cache
module are low and are
being recharged.
70 CACHE
DISABLED NO
CONFIGURATION
Informational The cache has not been
configured and therefore is
disabled. The cache can be
configured by using the
Array Configuration Utility
(ACU).
Table 20: LCD Message Descriptions
Message Type Description Action
230941-005_MSA1000_UG.book Page 208 Thursday, April 17, 2003 5:53 PM