User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Command Line Interface (CLI)
162 Modular SAN Array 1000 User Guide
Disabling the ACL
If the ACL has been set up, but the decision has been to not use it and not limit
access to the storage, the entries in the ACL need to be deleted. Use the following
command to delete all entries in the ACL.
Basic Command
SET ACL DISABLE
Example CLI Response
Disabling acl
Note: When this command is used, all existing ACL entries are automatically deleted.
All storage is immediately available to all connected servers.
230941-005_MSA1000_UG.book Page 162 Thursday, April 17, 2003 5:53 PM