User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Command Line Interface (CLI)
160 Modular SAN Array 1000 User Guide
Deleting Information from the ACL using the WWPN
Example Command
CLI> DELETE ACL WWPN=12345678-12345678 UNIT=1
Command Options
WWPN=12345678-12345678—entries will be deleted from the ACL of the
connection with a WWPN of 12345678-12345678.
UNIT=1—LUN 1 will be removed from the ACL of the named connection.
Example CLI Response
Disallowing 12345678-12345678 access to unit 1.
Changing the Name of a Connection
To change the name associated with a connection:
Basic Command
RENAME CONNECTION
Example Command
CLI> RENAME CONNECTION ABC XYZ
Command Options
ABC—the current name of the connection that is to be changed.
XYZ—the new name to assign to the connection, up to 16 alphanumeric
characters.
Example CLI Response
Connection(s) has been renamed successfully.
230941-005_MSA1000_UG.book Page 160 Thursday, April 17, 2003 5:53 PM