User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Command Line Interface (CLI)
158 Modular SAN Array 1000 User Guide
Two methods of entering LUN assignments are available:
■ Adding to the ACL using the connection name
■ Adding to the ACL using the WWPN
Note: There is no command to activate the ACL. Immediately after the first entry is
added to the ACL, access to the storage is limited to the servers and LUNs listed in the
ACL.
Adding to the ACL using the Connection Name
Example Command
CLI> ADD ACL CONNECTION=ABC UNIT=ALL
Command Options
CONNECTION=ABC—entries will be added to the ACL of the connection named
ABC.
UNIT=ALL—all LUN will be accessible to the connection named ABC.
Example CLI Response
Allowing 12345678-12345678 access to unit 2.
Adding to the ACL using the WWPN
Example Command
CLI> ADD ACL WWPN=12345678-12345678 UNIT=2
Command Options
WWPN=12345678-12345678—entries will be added to the ACL of the
connection with a WWPN of 12345678-12345678.
UNIT=2—LUN 2 will be accessible to the named connection.
Example CLI Response
Allowing 12345678-12345678 access to unit 2.
230941-005_MSA1000_UG.book Page 158 Thursday, April 17, 2003 5:53 PM