User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Command Line Interface (CLI)
156 Modular SAN Array 1000 User Guide
Selective Storage Presentation/Access Control List Commands
When multiple servers access the storage of the MSA1000, it becomes necessary
to restrict access to LUNS to specific servers. Some programs, including the
Array Configuration Utility (ACU), use the phrase “selective storage
presentation” (SSP) when discussing storage limitations. The CLI uses an Access
Control List (ACL) to enter the list of LUNs a server can access.
Each of the following commands is used to set up and manage the ACL:
■ Viewing the Connection Names
■ Viewing the ACL
■ Adding to the ACL
■ Deleting Information from the ACL
■ Changing the Name of a Connection
■ Changing the HBA of a Connection
■ Deleting a Connection Name
■ Disabling the ACL
Each of these tasks is defined in the following sections.
Note: Many commands are discussed in this section. To set up the ACL, the following
commands should be used in sequence:
■ Viewing the Connection Names
■ Naming a Connection to a server
■ Entering ACL information
230941-005_MSA1000_UG.book Page 156 Thursday, April 17, 2003 5:53 PM