User guide

Table Of Contents
Command Line Interface (CLI)
139Modular SAN Array 1000 User Guide
Locating all Drives for a Specific SCSI Bus
To flash the LEDs of all drives connected to a specific SCSI bus:
Example Command
CLI> LOCATE BUS 1
BUS 1
—all drives connected to bus number 1 will be flashed.
Locating all Drives in a Specific LUN
To flash the LEDs and locate all drives associated with a specific LUN:
Example Command
CLI> LOCATE UNIT 1
UNIT 1
—the drives in LUN 1 will be flashed.
UNIT ALL
—all drives incorporated into LUNs will be flashed.
Locating Specific Drives
To flash the LEDs to locate an individual drive or group of drives:
Example Command
CLI> LOCATE DISK DISK102-DISK106
DISK DISK102-DISK106
—the LEDs on drives in bays 2 through 6 in box 1
will blink.
Canceling a LOCATE Request
To stop the flashing of the drive LEDs caused by a previous Locate command
and return the drive LEDs to normal operations:
Example Command
CLI> LOCATE CANCEL
There are no available options for this command.
230941-005_MSA1000_UG.book Page 139 Thursday, April 17, 2003 5:53 PM