User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Command Line Interface (CLI)
128 Modular SAN Array 1000 User Guide
Example CLI Response
CLI>
Viewing LUN Information
The following information can be displayed for the LUN:
■ Unit identifier (user-defined name)
■ LUN status, including OK, Failed, and Rebuilding
■ List of the disks included in the LUN
■ List of the disks assigned as spares to the LUN
■ RAID level
■ Unit size, in MB
CLI> SHOW DISKS
Disk List: (box,bay) (bus,ID) Size Units
Disk101 (1,01) (0,00) 18.2GB 0
Disk102 (1,02) (0,01) 18.2GB 0
Disk103 (1,03) (0,02) 18.2GB none
Disk104 (1,04) (0,03) 18.2GB none
Disk105 (1,05) (0,04) 18.2GB none
Disk106 (1,06) (0,05) 18.2GB none
Disk107 (1,07) (0,08) 18.2GB none
Disk108 (1,08) (1,00) 18.2GB none
Disk109 (1,09) (1,01) 18.2GB none
Disk110 (1,10) (1,02) 18.2GB none
Disk111 (1,11) (1,03) 18.2GB none
Disk112 (1,12) (1,04) 18.2GB none
Disk113 (1,13) (1,05) 18.2GB none
Disk114 (1,14) (1,08) 18.2GB none
230941-005_MSA1000_UG.book Page 128 Thursday, April 17, 2003 5:53 PM