User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Command Line Interface (CLI)
125Modular SAN Array 1000 User Guide
Displaying a List of All Available Commands
To see a list of all commands:
Example Command
CLI> HELP DISPLAY_ALL
Command Options
DISPLAY_ALL—a list of all currently supported commands will be displayed.
Example Command Output
CLI> HELP DISPLAY_ALL
CLI>
Displaying list of all currently supported CLI commands:
? help
add unit add connection
add acl add spare
delete unit delete connection
delete acl delete spare
migrate unit expand unit
extend unit accept unit
accept units rename connection
set unit_id set this_controller_id
set other_controller_id set globals
set acl set connection
set prompt set unit
locate disk locate unit
locate bus locate box
locate all locate cancel
show connections show unit
show units show unit_id
show this_controller show other_controller
show version show disks
show globals show acl
show profile
230941-005_MSA1000_UG.book Page 125 Thursday, April 17, 2003 5:53 PM