User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Operation and Management
82 Modular SAN Array 1000 User Guide
Updating the Controller Firmware
To load the latest version of the firmware for the MSA1000 Controller, go to the
HP website at
http://www.hp.com.
From the HP StorageWorks MSA1000 page,
select the Software, Firmware & Drivers option.
Note: All supported operating systems obtain MSA1000 Controller firmware upgrades
from the HP website.
Installation instructions are available on the website.
You can use several methods to find out the version of the controller firmware you
are currently running:
■ In the CLI, use the SHOW VERSION command.
■ On the MSA1000 Controller LCD panel, use the arrow keys to scroll
backwards through the messages.
Each time the MSA1000 storage system is restarted, the first message that is
displayed includes the firmware version.
■ In the ACU, highlight the controller and view the details.
230941-005_MSA1000_UG.book Page 82 Thursday, April 17, 2003 5:53 PM