User guide

2-18 Compaq StorageWorks RAID Array 4100 User Guide
Connecting the Power
If you were not provided with a power cord for your computer, you should
purchase a power cord that is approved for use in your country.
The power cord must be rated for the product and for the voltage and current
marked on the product's electrical ratings label. The voltage and current rating
of the cord should be greater than the voltage and current rating marked on the
product. In addition, the diameter of the wire must be a minimum of 1.00 mm²
or 18AWG, and the length of the cord must be between 6 feet (1.8 m) and 12
feet (3.6 m). If you have questions about the type of power cord to use, contact
your Compaq authorized service provider.
A power cord should be routed so that it is not likely to be walked on or
pinched by items placed upon it or against it. Particular attention should be
paid to the plug, electrical outlet, and the point where the cord exits from the
product.
After all hardware components are installed and the unit is in place, the power
can be connected.
1. Plug the AC power cord into the RA4100. The power supply
automatically senses the input voltage. It is not necessary to select the
correct main voltage.
TROJ011.EPS
Figure 2-12. Connecting the power cord