User`s guide

3-10 StorageWorks Fibre Channel Storage Switch Service Guide
Replacing the Front Panel Assembly
The front panel assembly contains the front panel display, the front panel
buttons, the ON/OFF LED, and the Switch’s front panel.
SHR-1222A
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
2
1
Figure 3-6 Removing the Front Panel Assembly
Removing the Front Panel
Remove the front panel assembly as follows:
1.
If the Switch is online, take the Switch off-line as described in the
section Switch Offline.
2. With the Switch is off-line, turn off the power Switch and remove the
power cord.
3. Remove the Switch cover as described in the section Removing a Switch
Cover.
4.
Unplug the front panel display flat-ribbon connector 2 from the CPU
module with a gentle upward motion. Do not twist or rock the connector
as you may damage the pins. This cable is connected to the front panel
assembly and should not be removed from it.
Using the same care, remove the power LED connector 1 from the CPU
module.
NOTE: The cables are part of the front panel assembly. The front panel assembly
replacement part includes the installed cables.
5. Remove the screws at the side and bottom securing the front panel to the
chassis.