User`s guide

Repair and Replacement 3-7

SHR-1378

Figure 3-4. Interface Card - Media Interface Module and Card Extractor

NOTE: SNMP traps are generated on GBIC insertion and removal.

To replace an IBM GBIC module into an interface card:

1. On the front of the GBIC module is a locking bar, ensure it is to the

right side of the GBIC

2. Insert the GBIC module until its connector is firmly seated into the

appropriate port.

3. When firmly seated, lock the GBIC module in the slot by pushing the

locking bar to the left side of the GBIC. DO NOT force the locking bar,

reset if necessary.

Replacing a CPU Card

Replacing a CPU card involves removing the old card and installing a new

card. When you replace a CPU card you must install a new license key. Refer

to Appendix C.

Removing a CPU card

Referring to Figure 3-4, remove the CPU card as follows:

1. Disconnect the Switch from the power source and remove the cover,

front panel display connector 2 and power LED connectors 5.