User`s guide

2-26 StorageWorks Fibre Channel Storage Switch Sevice Guide
Table 2-3
Error Messages by Firmware Module
continued
Module Error Severity Explanation Action
HLO INVHLO (1) The path selection task has
received a HELLO message
with an invalid parameters
from a neighbor Switch.
Check that all paths and
routing tables are correct. If
they are not, reboot the
neighbor Switch.
Check the paths and routes
again. If they are still
incorrect, reboot the local
Switch.
LSDB LSID (2) A Link State Record received
as part of a Link State
Update has an out of range
domain ID.
Check that all paths are
correct. If any path is
missing to any Switch in any
part of the Fabric, reboot the
Switch with the missing
path.
MCAST ADDBRANC H (2)
A branch is being added to a
broadcast or multicast tree,
but the parameters are
incorrect.
If this is caused by a
configuration command,
check the parameter values.
Otherwise, check the
broadcast tree with the
bcastShow command. If the
tree is incorrect, reboot the
local Switch.
ADDPORT (3) A multicast routing table
programming failed.
Run the portLogShow
command. Contact
Customer Support.
NOPARENT (2) An error occurred while
computing a broadcast or
multicast tree.
Run the LSDbAllShow
command. Contact
Customer Support.
NOPARENT LSR (2)
An error occurred while
computing a broadcast or
multicast tree.
Run the LSDbAllShow
command. Contact
Customer Support.
REMPORT (3)
Removing an entry from a
multicast routing table failed.
Run the portLogShow
command. Contact
Customer Support.
continued