User`s guide

Troubleshooting 2-25
Table 2-3
Error Messages by Firmware Module
continued
Module Error Severity Explanation Action
INPORT (2) The input port in the IU
received by the path
selection task is out of range.
Check that all paths and
routing tables are correct. If
they are not correct, reboot
the local Switch.
MSG (2)
The path selection task has
received an unknown
message from another task.
Check that all paths and
routing tables are correct. If
they are not, reboot the
neighbor Switch.
Check the paths and routes
again. If they are still
incorrect, reboot the local
Switch.
REMDOMAI N (2) The message received from
a neighbor Switch has a
source domain ID out of
range.
Check that all paths and
routing tables are correct. If
they are not, reboot the
neighbor Switch.
Check the paths and routes
again. If they are still
incorrect, reboot the local
Switch.
SCN (3) The path selection task has
received a State Change
Notification message that it
does not recognize.
Check that all paths and
routing tables are correct. If
they are not, reboot the local
Switch.
VERSION (2) The FSPF protocol version
running on the local Switch
is lower than a neighbor’s
Switch.
Check the protocol version
on both Switches using the
fspfShow command. If the
two versions differ, update
the software on the local
Switch.
continued