User`s guide

Troubleshooting 2-23
Probable cause: Failure of G_Port or FL_Port ASIC
Action: Replace interface module
Probable cause: Failure of Interface module
Action: Replace interface module
Probable cause: Failure of motherboard
Action: Replace motherboard
Probable cause: Failure of GBIC module connector
Action: Replace GBIC module
Probable cause: Failure of Interface module
Action: Replace interface module
Probable cause: Failure of G_Port or FL_Port ASIC
Action: Replace interface module
Probable cause: Failure of GBIC module
Action: Replace GBIC module
SpinSilk Test Error Messages
The SpinSilk test is started with the Telnet spinSilk nMillions command where,
nMillions is the number of frames for the test to execute expressed as millions
of frames.
If you do not include the nMillions parameter, the spinSilk test runs until you
terminate the process by pressing <return>.
If the test does not find an error, there is no output through Telnet. If an error
is found, the following error messages are displayed.