User`s guide

Troubleshooting 2-15
RDRAM Test Error Message
The RDRAM test is initiated with the Telnet command rdramTest. Pressing
<Return> after entering the command starts the test.
This section shows the error output, the probable cause for the error, and the
suggested action.
If the test does not find an error, there is no output during the Telnet session. If
an error is found, the following message is displayed:
Feb 12 08:48:29
000 DIAG-RAMBUSTO, 1
R RAMBUS Timeout, port XX tbuf_acc bit 31 stuck high.
Probable cause: FL_Port interface card memory failure
Action: Replace FL_Port interface card
Feb 12 08:48:29
000 DIAG-RAMBUSPERR, 1
RAMBUS Parity Error, port XX, address 0xXXXX offset 0xXXXX.
Probable cause: FL_Port interface card memory failure
Action: Replace FL_Port interface card
Feb 12 08:48:29
000 DIAG-RAMBUSEOFC, 1
R RAMBUS EOF Location Error, port XX, address 0xXXXX, counter is
XX sb XX.
Probable cause: FL_Port interface card failure
Action: Replace FL_Port interface card
Feb 12 08:48:29
000 DIAG-RAMBUS, 1
R RDRAM Error, port XX, address XXXX offset 0xXX is 0xXX sb 0xXXXX\n")