User guide

StatusDescriptionItem
Off = Power cord is not attached, power supply
failure has occurred, no power supplies are installed,
facility power is not available, or disconnected power
button cable.
Blue = Identification is activated.UID button/LED2
Flashing blue = System is being remotely managed.
Off = Identification is deactivated.
Green = System health is normal.Internal health LED3
Amber = System health is degraded. To identify the
component in a degraded state, refer to HP Systems
Insight Display LEDs and Internal Health LED
Combinations.
Red = System health is critical. To identify the
component in a critical state, refer to HP Systems
Insight Display LEDs and Internal Health LED
Combinations.
Off = System health is normal (when in standby
mode).
Green = Power supply health is normal.External health LED (power supply)4
Amber = Power redundancy failure occurred.
Off = Power supply health is normal when in standby
mode.
Green = Network link exists.NIC 1 link/activity LED5
Flashing green = Network link and activity exist.
Off = No link to network exists.
If power is off, the front panel LED is not active. View
the LEDs on the RJ-45 connector for status by referring
to Rear Panel LEDs and Buttons.
Green = Network link exists.NIC 2 link/activity LED6
Flashing green = Network link and activity exist.
Off = No link to network exists.
If power is off, the front panel LED is not active. View
the LEDs on the RJ-45 connector for status by referring
to Rear Panel LEDs and Buttons.
Rear Panel Components
DescriptionItem
Quad port FC card, storage port, port 41
Quad port FC card, storage port, port 32
Quad port FC card, host port, port 23
144 Component Identification