Technical data
User input messa
ges
User input messages indicate that the system has encountered a situation that allows user input. The user
can select from a number of choices. If the user does not select one of the choices in a set amount of
time, the system selects the default setting. These user input messages only occur during system power
on, and not dur
ing runtime.
The array cont
roller Fault LED to the left of the LCD panel display window blinks on and off when a user
input message is currently being viewed and is available for input. If input is not provided within the
time-out period, the message remains but the LED stops blinking.
LCD message descriptions
The following table describes the MSA LCD messages.
Table 2 LCD panel messages
Message Type
Description Action
00 ARRAY CONTROLLER
FIRMWARE VER
<version>
Informational
Displays the current version
of firmware running on the
MSA array controller.
01 STARTUP COMPLETE
Informational
The array controller has
completed its power-on
sequence and is now
operational.
02 ENABLE V
OLUME
<n>? '<'=N
O,
'>'=YES
User input
An issue has been found
with a configured volume
that may result in data loss,
sothevolumehasbeen
disabled. The exact nature
of the issue is detailed in
apreviousLCDdisplay
message.
Yes =thevo
lume is enabled
(regardl
ess of the issue.) The
volume at
tempts to return to
its norma
l operating state
and the d
ata is accessible.
No =nots
electing any
option w
ithin the time-out
period =
the volume remains
disabl
ed. The volume stays
in the f
ailed state and the
data is
not be accessible.
Durin
gthistime,theusercan
attempt to fixtheissue.
no input = No
03 CRITICAL LOCK-UP
DETECTED. CODE=<n>
Error
Acriticalerrorhasbeen
detected by the array
controller firmware. To
prevent any possible
data loss, the firmware
has entered a lock-up
state. The provided code
contains engineering
specific information about
the lock-up condition.
In dual-controller
configurations where only
one controller is locked-up,
remove the array controller in
question, wait 10 seconds,
and then reinsert it ensuring
that it is fully seated in the
chassis.
In single-controller
configurations and in
dual-controller configurations
where both controllers are
locked-up, restart the MSA
chassis.
Should the issue persist,
contact HP support.
maintenance and service guide
35