Technical data

Federal Communications Commission. See
FCC,111
Fibre Channel I/O module
replacing,83
figures
LEDs
controller,22
fibre channel 1/0 module,25
firmware
cloning,105
cloning in redundant configurations,69
updating,105
floor mats, dissipating,116
G
German noise declaration,114
ground strap specifications,116
grounding
methods,62
methods,115
procedures,62
straps, wearing,116
suggested equipment for, 116
H
hard drive
blank, removing,72
blank, replacing,72
ejector levers,73,75
latches,73,75
LEDs
amber,23
recognizing,75
reconstructing,75
removing,73
removing in fault-tolerant systems,73
securing,75
hard drive firmware
updating,109
hazardous conditions
symbols on equipment,63
heel straps, using, 116
help
obtaining,11
hot-pluggable parts, MSA,67
HP
address for
FCC questions,112
series number, 112
technical support,11
telephone number
FCC questions,112
I
I/O EMU
removing,90
IEC EMC, worldwide regulatory compliance
notice,112
illustrated parts breakdown,13
informational messages
array controller restarting,51
array controller temperature ok,51
beacon off,51
beacon on ,50
cache batteries low, recharging,44
cache disabled no configuration,44
cache hardware enabled,43
cache hardware temporarily disabled,44
cache module # MB,43
configured volumes,49
EMU flash done,53
EMU flash started,53
fibre subsystem link ok,56
firmware flash done,53
firmware flashdoneonbox#,53
firmware flash started,53
firmware flash started on box #,53
firmware version,35
hard drive hot added box bay,46
hard drive hot removed box bay,46
hard drive position change detected,46
hard drive position charge invalid,46
initializing fibre subsystem,55
initializing PCI subsystem,55
initializing redundancy support,39
initializing SCSI subsystem,37
initializing subsystem,37
MSA1000 active controller,42
MSA1000 standby controller,42
new volume(s) detected,49
no volumes detected,49
non-compaq hard drive,46
obsolete cache data deleted,44
online upgrade complete,37
online upgrade fl ashing done,37
online upgrade flashing firmware,37
online upgrade flashing started,37
online upgrade redundancy halted,37
online upgrade restarting system,37
persistent mem disabled,57
persistent mem enabled,57
recovery ROM autoflash done,52
recovery ROM autoflash started,51
redundancy active active controller,39
redundancy active standby controller,39
redundancy halted expand active,40
redundancy halted firmware cloned,41
replacement hard drive found box,45
restarting system,36
ROM cloning done,52
ROM cloning started,52
scanning SCSI subsystem,37
smart hard drive alert box,46
spares cleared,50
startup complete,35
storage box EMU version,55
120