Technical data

device preparation
removing power,70
warnings and precautions,65
device, unloading from pallet,64
diagnostic tools,29
disposal, battery,114,115
dissipating floor mats, 116
document
conventions,10
prerequisites,9
related documentation,9
documentation
HP website,9
providing feedback,11
E
electrostatic damage prevention,115
electrostatic discharge See ESD,62
electrostatic discharge See ESD,115
electrostatic sensitive parts
handling,62
packaging,62
storing,62
transporting,62
enclosure expansion
ACU,96
ACU-XE,96
adding enclosures to existing MSA,95,95
attaching SCSI cables,95
rack considerations,95,95
recommended procedures,95
error messages
access control conflict detected,50
access control resources exceeded,50
array controller disabled,51
array controller overheated,51
array controller overheating,51
bad hard drive firmware box,46
bad SCSI bus mode non-LVD device found,
38
bad scsi target,38
cache data lost battery dead,43
cache hardware batteries,45
cache hardware failed and disabled,43
chassis nvram contents corrupted,39
cloning refused system halted,37
controller too old not supported,36
critical lockup detected,35
dual cache module size mismatch,43
EMU flash failed,53
fibre device hardware failure,56
fibre subsystem hardware failure,56
fibre subsystem link failure,56
fibre switch hardware failure,56
firmware flash failed,37
firmware flash failed on box #,53
fw version is not supported,38
hard drive failure box,46
I2C read failure,38
I2C write failure,38
invalid confi
g box 3<n>, bay<n>,47
invalid SCSI cabling,55
no cache module found,43
online upgrade flashing failed,37
online upgrade incomplete,37
PCI bridge ASIC self-test failure,55
PCI subsystem hardware failure,55
pilot 2 contrlr not supported,36
recovery ROM autoflash failed,52
redundancy failed cache Dimms mismatch,
42
redundancy failed cache size mismatch,40
redundancy failed firmware lockup,41
redundancy failed hardware failure,39
redundancy failed I/O request error,41
redundancy failed mismatch firmware,40
redundancy failed mismatch hardware,40
redundancy failed no second controller,42
redundancy failed out-of-memory,41
redundancy failed PCI Bus error,42
remove other controller now,42
ROM cloning failed,52
storage box EMU not responding,55
storage box fan degraded,54
storage box fan failed,53
storage box overheated,54
storage box overheating,54
storage box power supply failed,54
system halted for cache error,44
too many volumes detected,50
uncorrected ECC memory,56
unknown I/O module detected,57
volume expansion failure,49
volume rebuild failure,49
volume state disabled,47
volume state failed,47
volume state missing drives,48
volume state wrong hard drive replaced,48
ESD (electrostatic discharge)
obtaining additional information, 116
precautions, 62, 115
preventing,62
prevention measures, 115
storing products,115
transporting products,115
types of damage from,115
European Union, regulatory compliance notice,
113
F
fault tolerance, removing hard drives,73
FCC (Federal Communications Commission)
Class A Equipment, compliance notice,111
Class B Equipment, compliance notice, 111
declaration of conformity,112
modifications,112
notice,111
maintenance and service guide
119