Specifications

Operation and Management

50 MSA1000 Reference Guide

To remove the blower from the power supply:

1. Push in on the two port wine-colored blower tabs 1 while pulling on the

blower element 2. See Figure 16 for an illustration.

Figure 16: Replacing the blower

Caution: Pressing on the center section of the blower can damage the blades.

To prevent this, press only on the outer edge of the blower.

2. Align the new blower’s guidepost 2 with the power supply connector 1.

Slide the replacement blower into the blower base 4 until the tabs 3 snap into

place.

See Figure 17 for an illustration.