User`s guide

Figure 3–2: RA3000 Pedestal Cabled for Single-Bus Configuration
J11
J16
ZK-1465U-AI
8. Remove the knockout plate above the D1 OUT label on the rear panel
of the base pedestal (see Figure 2–3).
9. Attach one end of cable assembly 17-04454-01 to the D1 OUT
bulkhead opening. Connect the other end of the cable to the device #1
backplane connector (see Figure 3–2). This is the second SCSI bus, and
it will be connected to the expansion pedestal option.
10. Set the bus configuration switch to 7 by depressing the increase or
decrease buttons below and above the number display (see Figure 3–3).
3–4 Reconfiguring the RA3000 Pedestal for the Expansion Pedestal Option