User`s guide

2.2.4.2 Setting the KZPBA-CB SCSI ID
After you determine the console environment variables for the KZPBA-CBs
on the shared SCSI bus, use the set console command to set the SCSI ID.
For a TruCluster configuration, you will most likely have to set the SCSI
ID for all KZPBA-CB UltraSCSI adapters except one. And, if you are using
a DS-DWZZH-05, you will have to set the SCSI IDs for all KZPBA-CB
UltraSCSI adapters.
_______________________ Note _______________________
You will have problems if you have two or more SCSI adapters
at the same SCSI ID on any one SCSI bus.
If you are using a DS-DWZZH-05, you cannot use SCSI ID 7 for
a KZPBA-CB UltraSCSI adapter; SCSI ID 7 is reserved for
DS-DWZZH-05 use.
Use the set console command as shown in Example 2–7 to set the SCSI
ID. In this example, the SCSI ID is set for KZPBA-CB pkc on the
AlphaServer 4100 shown in Example 2–5.
Example 2–7: Setting the SCSI Bus ID
P00>>> show pkc0_host_id
7
P00>>> set pkc0_host_id 6
P00>>> show pkc0_host_id
6
2.2.5 Cabling Illustrations
This section provides illustrations and tables that are helpful while you are
configuring clusters.
Figure 2–2 shows the front view of the StorageWorks RAID Array 3000
controller shelf.
Using the StorageWorks RAID Array 3000 in a TruCluster Configuration 2–17