User`s guide

Server configuration using an RA3000 storage subsystem. For TruCluster
Available Server Software, skip the first step as you do not use Memory
Channel. Also, you may save time by installing the Memory Channel
adapters, redundant network adapters (if applicable), as well as the
KZPBA-CB UltraSCSI host adapters all at the same time.
Follow the directions in the referenced documentation, or the steps in the
referenced sections and tables at each step, returning to Table 2–1 when
you have completed the steps in the referenced section or table.
Table 2–1: Configuring TruCluster Hardware for Use with the RA3000
Step Action Refer to:
1 Power down the system and install the
Memory Channel module(s), cables, and
hub(s), if a hub is required.
TruCluster Software
Products Hardware
Configuration Chapter 5
ab
2 Install network adapters if required to
provide network failover for TruCluster
Available Server Software.
Install Ethernet or FDDI network adapters. User’s guide for the
applicable Ethernet or FDDI
adapter, and the user’s guide
for the applicable system
Install ATM adapters if using ATM.
ATMworks 350 Adapter
Installation and Service
3 KZPBA-CB termination
KZPBA-CB PCI-to-Ultra
SCSI Differential Host
Adapter User’s Guide
The preferred method of radial
connection to a DWZZH: Ensure that the
eight KZPBA-CB internal termination
resistor SIPs, RM1 - RM8, are installed
Section 2.2.2 and Figure 2–1
Using external termination and Y cables:
Remove the eight KZPBA-CB internal
termination resistor SIPs, RM1 - RM8
Section 2.2.2 and Figure 2–1
4 Install the KZPBA-CB UltraSCSI host
adapter in the PCI slot corresponding to the
logical bus to be used for the shared SCSI
bus. Ensure that the number of adapters are
within limits for the system, and that the
placement is acceptable.
KZPBA-CB PCI-to-Ultra
SCSI Differential Host
Adapter User’s Guide
2–4 Using the StorageWorks RAID Array 3000 in a TruCluster Configuration