Specifications

Removal and Replacement Procedures 2-17
Fan
To remove the fan:
1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2. Remove the front bezel. See “Front Bezel” earlier in this chapter.
3. Remove the access panel. See “Access Panel” earlier in this chapter.
4. Disconnect the fan power cable from the system board fan connector
.
5. Use a Phillips screwdriver to remove the four mounting screws from the rear of the
server
.
6. Pull the fan out and away from the chassis .
1
2
3
Figure 2-13. Removing the fan
To replace the fan, reverse steps 2 through 6.