Specifications

Removal and replacement procedures 29

• Do not sharply bend any cable. A sharp bend can break the internal wires.

• Never bend a SATA data cable tighter than a 30 mm (1.18 in) radius.

• Never crease a SATA data cable.

• Do not rely on components like the drive cage, power supply, or system cover to push cables

down into the chassis.

To remove power supply cables from the system board connectors:

Squeeze on the top of the retaining latch attached to the cable end of the connector.

2. Grasp the cable end of the connector and pull it straight up.

CAUTION: Always pull the connector - NEVER pull on the cable. Pulling on the cable could damage

the cable and result in a failed power supply.

Figure 3 Unplugging power cables