Specifications

Diagnostics and Troubleshooting 3-25
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of
Problem
Action
1752-Slot X Drive
Array – This
controller is not
supported in
systems with more
than 3 GB of
memory. The array
controller will be
disabled. (RESUME
= F1 KEY)
None The array controller
cannot access
physical system
memory above the
3-GB address range.
Remove the array controller and replace
with a version that addresses memory in
the required range.
1760-Fixed Disk 0
does not support
Block Mode
None Hard drive error
detected.
Run the server setup utility and correct.
1761-Fixed Disk 1
does not support
Block Mode
None Hard drive error
detected.
Run the server setup utility and correct.
1764-Slot X Drive Array – Capacity Expansion Process is temporarily
disabled (followed by one of the following):
Expansion will resume when Array Accelerator has been reattached.
Expansion will resume when Array Accelerator has been replaced.
Expansion will resume when Array Accelerator RAM allocation is
successful.
Expansion will resume when Array Accelerator battery reaches full
charge.
Expansion will resume when automatic data recovery has been
completed.
Reattach or replace array accelerator,
wait until the array accelerator batteries
have charged, or for Automatic Data
Recovery to complete, as indicated.
1765-Slot X Drive Array Option ROM Appears to Conflict With an ISA
Card. ISA cards with 16-bit memory cannot be configured in
memory range C0000 to DFFFF along with the SMART-2/E 8-bit
Option ROM due to EISA bus limitations.
Please remove or reconfigure the ISA card.
■ Remove or reconfigure conflicting
ISA cards.
■ Disable “shared memory” on any
ISA network cards that may be
installed.
1766-Slot X Drive Array requires System ROM Upgrade. Run
Systems ROMPaq Utility.
Run the latest System ROMPaq Utility to
upgrade the system ROM as indicated.
continued