Specifications

Diagnostics and Troubleshooting 3-17
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of
Problem
Action
805-The bootstrap
processor is not
the lowest
stepping
processor in the
system. This is
unsupported
configuration.
Swap the position
of the processors
on the system
board to correct
this issue.
None System has detected
that the processors
in the system are not
the same stepping
and that the
processor in
processor slot 1 has
a lower stepping
than the processor in
processor slot 2. The
processor in
processor slot 2
must have the same
or lower stepping
than the processor in
processor slot 1.
(Processor stepping
is a designation that
reflects the
processor
generation.)
1. Remove the processor from
processor slot 1.
2. Remove the processor from
processor slot 2.
3. Install the processor from
processor slot 1 into processor
slot 2.
4. Install the remaining processor in
the available processor slot.
806-NVRAM has
been reset
Please power off
the system and
restore SW1.2 to
the default
position. Run BIOS
Setup to set
default values.
System Halted.
None System configuration
switch (SW1),
position 2 has been
turned On and the
system configuration
data has been
cleared from CMOS.
This switch must be
returned to the
default Off position
for normal operation
and the ability to
save configuration
setup data.
The system must be
reconfigured.
1. Remove power from the system.
2. Locate the system configuration
switch (SW1). See Chapter 4 for
instructions.
3. Return SW1.2 to the Off position.
4. Restart the system.
5. Press F10 to run the server setup
utility and configure the system.
6. Select the primary operating
system.
7. Set the date and time.
8. Complete additional configuration
as needed.
continued