Specifications

Diagnostics and Troubleshooting 3-9
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of
Problem
Action
(Run System
Configuration Utility
– F10 key)
None A configuration error
occurred during
POST.
Press F10 to run server setup utility.
Unsupported
Processor
Detected System
Halted
1 long, 1 short Processor not
supported by current
system ROM.
Check documentation for supported
processors. If supported, remove the
processor and update system to latest
ROM, then reinstall processor.
101-ROM Error 1 long, 1 short System ROM
checksum.
Run Diagnostics. Replace failed
assembly as indicated.
101-I/O ROM Error None Options ROM
checksum.
Run Diagnostics. Replace failed
assembly as indicated.
102-System
Board Failure
None 8237 DMA
controllers, 8254
timers, and so on.
Replace the system board. Run the
Compaq server setup utility.
104-ASR-2 Timer
Failure
None System board failure. Run Diagnostics. Replace failed
assembly as indicated.
105-Current
System ROM is
corrupt – now
booting redundant
System ROM
2 long Nonbooted ROM
image is corrupted.
Flash the ROM utilizing ROMPaq. Refer
to the ROMPaq Disaster Recovery
section of this guide.
162-System
Options Not Set
2 short Configuration
incorrect.
Run the server setup utility and correct.
163-Time & Date
Not Set
2 short Invalid time or date
in configuration
memory.
Run the server setup utility and correct.
164-Memory Size
Error
2 short Configuration
memory incorrect.
Run the server setup utility and correct.
172-Configuration
Non-volatile
Memory Invalid
None Nonvolatile
configuration
corrupted.
Run the server setup utility and correct.
173-Slot ID
Mismatch
None Board replaced,
configuration not
updated.
Run the server setup utility and correct.
continued