Specifications

3-8 Compaq ProLiant ML350 Maintenance and Service Guide
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of
Problem
Action
ECC Multiple Bit
Error Detected in
DIMM:
None A memory module
failure generated a
multiple bit error that
could not be
corrected.
Run Diagnostics and replace failed
memory module as indicated.
FATAL ROM
ERROR: The
System ROM is
not properly
programmed.
1 long, 1 short The System ROM is
not properly
programmed.
Flash the ROM or replace the physical
ROM part.
Initialization
failure.
Re-seat the
processor and
Processor Power
Module before
attempting
replacement
None Processor was not
fully seated.
A processor internal
failure occurred.
1. Reseat the processor.
2. Replace the processor if the failure
recurs.
Invalid electronic
serial number
None Serial number in
BIOS is incorrect.
Run server setup utility to program
serial number.
No SCSI Devices
Detected
None No SCSI devices are
connected to the
boot controller.
Verify configuration. Check SCSI cable,
attached drives, and SCSI IDs.
Non-System disk
or disk error
None No bootable disk
partition was found
on the boot drive.
1. Remove diskette from diskette
drive.
2. Check controller order in server
setup utility.
3. Check boot order in server setup
utility.
4. Reinstall operating system.
Parity Check 2 None A PCI device
generated a parity
error 2.
Remove recently added PCI adapters.
Add the adapters again one at a time to
determine which is generating errors.
Replace the failed device.
(RESUME – F1 key)
None As indicated to
continue.
Press F1.
continued