Specifications

Removal and Replacement Procedures 2-41
Feet
To remove the feet from the chassis, one at a time:
1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2. Remove the front bezel door. See “Front Bezel Door” earlier in this chapter.
3. Place the server upside down.
4. Remove the Torx T-15 screw (1) securing each foot to the chassis.
5. Pivot each foot (2), then pull it off the base (3) of the chassis.
3
2
1
Figure 2-37. Removing the feet from the chassis
Reverse steps 1 through 5 to replace the feet.