Specifications

2-40 Compaq ProLiant ML350 Maintenance and Service Guide
Power Supply
To remove the power supply:
1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2. Remove the access panel. See “Access Panel” earlier in this chapter.
3. Disconnect the internal power supply connectors from all system devices and the system
board.
4. With a Torx T-15 screwdriver, remove the four screws (1) securing the power supply to
the rear of the chassis.
5. Slide the power supply (2) forward until it stops, and then lift the power supply from the
chassis.
1
2
Figure 2-36. Removing the power supply
Reverse steps 1 through 5 to replace the power supply.