Specifications

Removal and Replacement Procedures 2-33
Processor Terminator Module
A processor terminator module must be installed in each empty processor slot. The processor
terminator module is removed to install a second processor and PPM.
To remove the processor terminator module:
1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2. Remove the access panel. See “Access Panel” earlier in this chapter.
3. Press the release tabs (1) toward the center of the module, and then gently lift the
processor module (2) to remove it.
1
1
2
Figure 2-30. Removing the processor terminator module
Reverse steps 1 through 3 to replace a processor terminator module.