Specifications

2-20 Compaq ProLiant ML350 Maintenance and Service Guide
Hot-Plug Hard Drive or Drive Blank
The ProLiant ML350 server is optionally available with hot-plug hard drives.
To remove a hot-plug hard drive or drive blank:
1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2. Open the front bezel door. See “Front Bezel Door” earlier in this chapter.
3. Press down the release tab (1) on the side of the drive, then pull the drive or the drive
blank (2) out of the drive bay.
1
2
Figure 2-18. Removing a hot-plug hard drive or drive blank
Reverse steps 1 through 3 to replace a hot-plug hard drive or hard drive blank.