Specifications

2-6 Compaq ProLiant ML350 Maintenance and Service Guide
Front Bezel Door
CAUTION: Before removing the front bezel door, make sure that the server is powered down,
all cables are disconnected from the back of the server, and the power cord is disconnected
from the grounded (earthed) AC outlet.
To remove the front bezel door:
1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2. If the keylock is locked, unlock using the included key (1).
3. Open the front bezel door fully to the right (2).
4. Lift the bezel door upward (3), and then away from the chassis.
1
2
3
Figure 2-1. Removing the front bezel door
Reverse steps 1 through 4 to replace the front bezel door.
NOTE: When replacing the front bezel door, ensure that the bottom hinge points are properly placed in the chassis
before rotating the front bezel door back into its original position.