Installation guide

4-10 Compaq ProLiant ML350 Setup and Installation Guide
For use with 1-GHz or greater Intel Pentium III processor-based server models only
Compaq Confidential – Need to Know Required
Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:
Part Number: 201345-001 File Name: e-ch4 Cabling Guidelines.doc Last Saved On: 7/11/00 9:08 AM
Installing an Internal to External SCSI Connector
If you are not using one or both SCSI channels (A or B) internally, you may
install an internal to external SCSI connector in the SCSI knockout locations
on the rear of the chassis. To install an internal to external SCSI connector,
follow the steps below:
1. Using a Torx T-15 screwdriver, remove the screw holding the SCSI
knockout cover plate and remove the cover plate
.
2. Insert the SCSI connector into the open area. Secure the external
SCSI connector
to the chassis using the screws provided with the
external SCSI connector option kit.
1
2
3
4
Figure 4-9. Installing an internal to external SCSI connector