Installation guide

Cabling Guidelines 4-7

For use with 1-GHz or greater Intel Pentium III processor-based server models only

Compaq Confidential – Need to Know Required

Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:

Part Number: 201345-001 File Name: e-ch4 Cabling Guidelines.doc Last Saved On: 7/11/00 9:08 AM

Connecting an Integrated Wide-Ultra3 SCSI

Controller to a Removable Media or Other Device

The following steps detail the procedure for cabling an integrated Wide-Ultra3

SCSI controller (channel B) to a removable media or other device:

1. Follow the steps in the sections following “Installing a Device in a

Removable Media Device Bay” in Chapter 3. Make sure the SCSI ID is

uniquely set on each device.

2. Locate the SCSI cable that is attached to SCSI channel B.

3. Install the next available connector to the device.

4. Install the next available power connector to the device.

Figure 4-6. Cabling an integrated Wide-Ultra3 SCSI controller to a removable

media or other device