Installation guide

4-6 Compaq ProLiant ML350 Setup and Installation Guide

For use with 1-GHz or greater Intel Pentium III processor-based server models only

Compaq Confidential – Need to Know Required

Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:

Part Number: 201345-001 File Name: e-ch4 Cabling Guidelines.doc Last Saved On: 7/11/00 9:08 AM

Connecting an Integrated Wide-Ultra3 SCSI

Controller to an Internal Non-Hot-Plug Hard Drive

The following steps detail the procedure for cabling an integrated Wide-Ultra3

SCSI controller (channel A) to an internal non-hot-plug hard drive:

1. Follow the steps in the sections following “Installation and Removal

Guidelines for SCSI Hard Drives” in Chapter 3.

2. Make sure the SCSI ID is uniquely set on each device.

3. Install the next available SCSI connector to the hard drive.

4. Install the next available power connector to the hard drive.

Figure 4-5. Cabling an integrated Wide-Ultra3 SCSI controller to an internal

non-hot-plug hard drive