Installation guide

3-34 Compaq ProLiant ML350 Setup and Installation Guide
For use with 1-GHz or greater Intel Pentium III processor-based server models only
Compaq Confidential – Need to Know Required
Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:
Part Number: 201345-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 7/24/00 9:23 AM
Removing a Second Processor and
Processor Power Module (PPM)
For an illustrated overview of this procedure, refer to the Quick Start Poster
included in the shipping box or to the System Configuration Label located on
the inside of the access panel.
Removing a Second Processor
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: Do not remove the processor heatsink unless you are replacing the
processor. When the heatsink is removed, its thermal seal to the processor is
broken, and the thermal effectiveness of the heatsink is compromised. You
must replace it with a new heatsink.
CAUTION: Before removing the access panel, make sure that the server is
powered down, all cables are disconnected from the back of the server, and the
power cord is disconnected from the grounded (earthed) AC outlet.
1. Follow the steps in “Removing the Access Panel” at the beginning of
the chapter.
2. Locate the processors and PPMs as shown in Figure 3-35 and Table 3-4.
4 23 1
Figure 3-35. Locating the processors and Processor Power Modules (PPMs)