Installation guide

Hardware Options Installation 3-29

For use with 1-GHz or greater Intel Pentium III processor-based server models only

Compaq Confidential – Need to Know Required

Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:

Part Number: 201345-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 7/24/00 9:23 AM

Removing a Memory Module

To remove a DIMM:

CAUTION: Before removing the access panel, make sure that the server is

powered down, all cables are disconnected from the back of the server, and the

power cord is disconnected from the grounded (earthed) AC outlet.

1. Follow the steps in “Removing the Access Panel” at the beginning of

this chapter.

2. Press outward on both latches of the DIMM socket at the same time.

This step releases the DIMM and pushes it partially out of the socket.

3. Lift the DIMM from the socket.

Figure 3-31. Removing a DIMM

4. Reinstall the access panel.