Installation guide

3-22 Compaq ProLiant ML350 Setup and Installation Guide

For use with 1-GHz or greater Intel Pentium III processor-based server models only

Compaq Confidential – Need to Know Required

Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:

Part Number: 201345-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 7/24/00 9:23 AM

Installing and Removing an Expansion Board

To install an expansion board:

CAUTION: Before removing the access panel, make sure that the server is

powered down, all cables are disconnected from the back of the server, and the

power cord is disconnected from the grounded (earthed) AC outlet.

IMPORTANT: It may be necessary to remove the slot cover next to the slot in which you

are installing a card.

1. Follow the steps in “Removing the Access Panel” earlier in this chapter.

2. If an expansion board retainer is in place, loosen the thumbscrew of

the expansion board retainer, then pull the retainer

out and away from

the chassis.

Figure 3-25. Removing the expansion board retainer