Installation guide

3-16 Compaq ProLiant ML350 Setup and Installation Guide
For use with 1-GHz or greater Intel Pentium III processor-based server models only
Compaq Confidential – Need to Know Required
Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:
Part Number: 201345-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 7/24/00 9:23 AM
Installing a Device Into a Removable Media Device
Bay
The ProLiant ML350 includes four removable media device bays. The lower
two bays are occupied with a 3.5-inch diskette drive and an IDE CD-ROM
drive; the upper two removable media device bays are vacant. You can install
two half-height devices or one full-height device into these bays.
IMPORTANT: You must set the SCSI device ID equal to the bay number. Select a unique
SCSI device ID for each device. See Figure 3-8 for bay numbering.
Installing a Half-Height Removable Media
Device
To install a 5.25-inch device:
CAUTION: Before removing the access panel, make sure that the server is
powered down, all cables are disconnected from the server, and the power cord
is disconnected from the grounded (earthed) AC outlet.
1. Follow the steps in “Removing the Access Panel” at the beginning of
this chapter.
2. To configure the device, set the SCSI ID. You must manually set the
SCSI ID on each device to a unique value. Refer to the documentation
provided with the device for instructions on setting the SCSI ID.
3. Remove all terminating jumpers from third-party SCSI devices.
(Compaq SCSI non-hot-plug hard drive cables are terminated.)
4. Install guide screws on the sides of the drive.
5. Slide the drive into the drive bay until it clicks into place.