Installation guide

Hardware Options Installation 3-9

For use with 1-GHz or greater Intel Pentium III processor-based server models only

Compaq Confidential – Need to Know Required

Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:

Part Number: 201345-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 7/24/00 9:23 AM

Installing a Non-Hot-Plug Hard Drive into a

Non-Hot-Plug Drive Cage

To install a 3.5-inch non-hot-plug hard drive into a non-hot-plug drive cage:

CAUTION: Before removing the bezel, make sure that the server is powered

down, all cables are disconnected from the server, and the power cord is

disconnected from the grounded (earthed) AC outlet.

1. Follow the steps in “Removing the Access Panel” and “Removing the

Removable Media Device Blanks” earlier in this chapter.

2. Loosen the thumbscrews and remove the drive cage door .

Figure 3-9. Loosening the thumbscrews and removing the drive cage door

3. To configure the device, set the SCSI ID. You must manually set the

SCSI ID on each device to a unique value in the range of 0 to 6 for each

SCSI bus. Refer to the documentation provided with the drive for

instructions on setting the SCSI ID.

IMPORTANT: It is recommended that you set the SCSI ID equal to the bay number. See

Figure 3-7 for bay numbering.

4. Remove all terminating jumpers from third-party SCSI devices.

(Compaq SCSI non-hot-plug hard drive cables are terminated.)

5. Install two guide screws on each side of the drive. Be sure the rear

screws are secured in the holes farthest back on the drive and the guide

screws line up with the guide slots.