Installation guide

Hardware Options Installation 3-5

For use with 1-GHz or greater Intel Pentium III processor-based server models only

Compaq Confidential – Need to Know Required

Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:

Part Number: 201345-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 7/24/00 9:23 AM

Removing the Removable Media Device

Blanks

NOTE: The blanks must be removed from the chassis to install a storage device in its

place. The tray on the blank is used to mount hard drives into removable media device

bays.

To remove a removable media device blank from the front chassis:

CAUTION: Before removing a removable media device blank, make sure that

the server is powered down, all cables are disconnected from the server, and

the power cord is disconnected from the grounded (earthed) AC outlet.

1. Follow the steps in “Removing the Access Panel” earlier in this chapter.

2. Push up on the drivelock to release the blanks.

3. Gently pull the blank away from the front chassis, then remove the

blank.

Figure 3-4. Pushing up on the drivelock and removing a removable media

device blank

NOTE: The interior of the server may look different depending on the model purchased.

To replace a removable media device blank, reverse the above procedure.